Software and Firmware ROTALIGN

ROTALIGN Shaft Firmware 2.06

Date: 01.Dec. 2000


Upgrades any ROTALIGN shaft alignment system from any version 2.0x to version 2.06

What's new in this version:

 

  • The START button in the Move Function does not show until after the test for autostart has been performed.
  • The various sensor status messages in the Move Function are now shown until the move
    starts. After the move starts, the ‘READING’ and ‘CENTERED’ messages are no longer shown.
  • The sporadic graphic break-up in the Move Function was corrected.
  • Dial indicator value calculation from the laser values was corrected to show zero readings at 12 o’clock.
  • The order of X2 and Y2 in the XY-View screen was put in the same order as X1 and Y1.
  • The text editor matrix now has a comma (,).
  • Display of X and Y coordinates to 1 micron.
  • Improved low temperature performance.
  • Report bug concerning swapped left machine values in printed report was fixed.



Only for ROTALIGN, licence code required

 

Download (1.06 MB)

 

 

 

back