- Products and Services
- Condition Monitoring Systems
- Vibration Analysis and Balancing
- Vibration Analyzer
- VIBXPERT EX
Intrinsically safe vibration analysis instrument and field balancer
Approved for ATEX Zone 1
Intuitive joystick operation (left- or right-handed)
Fast data acquisition with "trending spectra"
Robust aluminum housing
Compatible with VIBCODE transducer
Highest resolution for detailed frequency analysis
Interface to machine protection systems for further analysis
Find out more …
Vibration analysis in explosive environments
VIBXPERT EX is a high-performance, intrinsically safe, fully-featured data collector, vibration analyzer and field balancer for easy condition monitoring and troubleshooting of rotating equipment in explosive environments such as petrochemical plants, refineries, offshore oil rigs, etc.
VIBXPERT EX collects field data including vibration information, bearing condition, inspection and process data and seamlessly integrates with the OMNITREND Center software platform for in-depth analysis.
The modular firmware structure allows you to upgrade the VIBXPERT EX from a route data collector to a full-blown troubleshooting device with advanced features such as coast down/run-up measurements, event recording, ODS & modal analysis and cross-channel phase measurement.
It is also possible to connect the VIBXPERT EX to protection systems via the buffered outputs. This enables you to perform additional analysis such as shaft vibration, shaft centerline plots or orbits e.g. on turbines, compressors and other turbomachinery.
As with all our data collectors and vibration analyzers, you will benefit from free software and firmware updates, and low ownership cost.
VIBXPERT Firmware Version 2.33 build 810
New firmware module 'E registration' provides route-based data collection, timewaveform and FFT analysis
Support for new processor and memory revision
Support of mainboard hardware status 14X and 15X
Reset status of measurement tasks to 'unmeasured'.
All measurement tasks below the current hierarchy level are set to "unmeasured".
Old results are retained and new results are added.
Low pass filter can be activated. The filter frequency (1kHz or 10kHz) depends on the start and stop speeds.
When using time-synchronous averaging, the speed deviation is checked and the averaging
function is discontinued if the deviations become too large.
If the ESC button is pressed, a confirmation prompt appears to prevent the unintentional
discontinuation of measurement with the loss of data.
The reference edge of the trigger signal is now adjustable for phase calculation
The signal edge of either the incoming or outgoing trigger mark can be selected as the reference
Higher maximum input values for weight (500 kg) and radius (100m).
How to install the latest firmware update?
Download the VIBXPERT I firmware file on your PC.
Unpack the file and run the VIBXPERT Update tool. Please use the latest VIBXPERT UpdateTool.
Follow the instructions on the screen.
Need an update?
VIBXPERT smart tools
The VIBXPERT utility software is used for data transfer between the instrument and a PC.
The VIBXPERT Client software is used to demonstrate the operation of the VIBXPERT instrument on a PC or Laptop.