Interested?
Find out more …
The universal brackets for shaft alignment
Stored pre-mounted in the case for instant usage
Mounts on machine shaft in less than a minute
Standard chains fit shaft and coupling diameters of approx. 15 mm to 200 mm / 5/8“ to 7 7/8“
This universal bracket set contains all parts needed for quick, stable mounting of the measurement components.
It fits onto any shaft or coupling approx. 15 mm to 200 mm /5/8" to 7 7/8“ in diameter. Stored pre-mounted in the case, the brackets are always ready to use and quickly in place.
The chain may be used as a plumb bob to accurately determine the dimension from coupling center to front foot.
The universal brackets with quick magnetic mount
Instant set-up
Fits onto any ferromagnetic surface
Extremely stable yet easy to readjust
This bracket type is one of the most commonly purchased accessory. Instant mounting on any ferromagnetic surface: just place the compact magnetic brackets onto coupling flanges or shaft faces and you're all set!
Four powerful magnets hold sensors firmly in place for measurement – even on narrow coupling flanges – yet allowing extremely easy and flexible adjustment.
It can also be used on large diameter couplings when placed perpendicular to the shaft.
Brackets for tight spaces
Fits between coupling and machine housing
Mounts in only 8 mm / 5/16“ space
Slip-nut design mounts quickly
Fits diameters up to 160 mm / 6 5/16“
Only 8 mm (5/16") thick, this bracket offers an ideal solution to those occasional tight squeezes between coupling and machine housing.
The case includes one complete set for both sides of the shaft or coupling, including various threaded rods and quick-mounting slip nuts. For shafts of diameter up to 160 mm / 6 5/16".
Brackets for non-rotating shafts
A versatile bracketing solution:
Slides around coupling flange or shaft end
For diameters of 80 mm / 3 1/8“ and up
Use on one or both coupling sides
Can also be used for live trend application and bore alignment
Can be used on both flat and curved vertical and horizontal surfaces
This bracket allows measurement for shaft alignment when one or both shafts cannot be rotated. Place the magnetic sliding bracket upon the back of the coupling or front corner of the uncoupled shaft and slide it around from one measurement position to the next. Suitable for shaft/coupling diameters from approx. 80 mm (3 1/8") and up.
Magnetic brackets for very large couplings
Suitable for very large couplings with large bolt holes
No radial clearance required
Fits onto any ferromagnetic surface
Extremely stable, but easy to adjust
Can be used for shaft, bore and Live Trend applications
This bracket can replace the compact chain-type bracket for large couplings with large boltholes. They really come in handy when radial clearance around the coupling rim is limited. This bracket allows the laser beam to be directed through a coupling bolthole with the laser and sensor mounted below the rim.
Universal mounting for quick and easy cardan shaft alignment
The special cardan brackets with rotating arm allow cardan shaft alignment without removal of the shaft.
Quick measurement set-up
No need to remove the shaft
Fits shaft diameters of approx. 50 mm to 500 mm / 2" to 20"
Two bracket configurations exist:
ALI 2.451 suitable for limited rotation angle
ALI 2.461 suitable for 180° rotation angle